« Initial State of the Structure Pane   |   Adding or Deleting Loop Specifications »

Adding or Deleting Column/Row Specifications

Designer
This manual is in pilot operation.

To add Column/Row Specifications to a form, operate as follows in the Layout Display Area of the Structure Pane.

  1. Click to select the Axis Specification or Loop Specification that you want to set as the parent of the Column/Row Specification to be added. Refer to the icons below (in the initial state, there are no Loop Specifications).

    Icons.c …​ Axis Specification (Horizontal Axis)
    Icons.r …​ Axis Specification (Vertical Axis)
    Icons.l …​ Loop Specification

    The Add Column/Row Spec. button to the right of the Layout Display Area becomes clickable.

  2. Click Add Column/Row Spec..

    A Column/Row Specification is added as a child of the selected Axis Specification or Loop Specification. If child specifications already exist, the new specification is added after them (to the right or below).

  3. To move a Column/Row Specification to a different position, click the Previous or Next button to move it.

To delete a Column/Row Specification, click to select the target Column/Row Specification, then click the Delete button.